Archive for the ‘Bar Rails’ Category

New Bar Rail Moldings & Parts by HWI

We recently launched our new website and webstore which includes a few new bar rail offerings for home and commercial bar building projects. Pictured below is our BR475-3CM Bar Rail Molding We make our BR475-3CM bar rail molding with a 3CM top notch to fit over standard thickness granite or any other material suitable for a bar top including hardwoods, tile or metal. A 3/4 bottom notch is provided to receive the plywood sub top under the granite necessary for attaching the bar rail. BR475-3CM is available online in our standard wood species and can be customized in a variety…

Read More »

Finishing Your Bar Rail Molding

PRE-FINISHING YOUR BAR RAIL MOLDING PRIOR TO INSTALLATION IS NEVER A GOOD IDEA AND IS NOT RECOMMENDED. Once you have viewed our installation video and have properly installed the bar rail molding we suggest the following steps. Mask off and protect the area where the bar rail meets the main bar top and begin the sanding process with 100 grit sand paper moving on up to 180 grit. Higher grits of sandpaper may be used but keep in mind the higher the grit and polish on the wood the less the stain will penetrate. Natural/clear finishes are not affected as…

Read More »

How to Build a Bar – Standard Dimensions, Specs & Resources

What are standard bar dimensions? How tall is a standard bar? How wide should you make a bar top? How do you build a home bar? How do you install Chicago bar rail? How do you cut and install curved radius bar rails for corners? These are the questions we receive all day, every day by wood workers, architects and contractors building home bars and commercial bars alike. Hardwoods Incorporated is now introducing our Bar Building Resources. Visit our new Bar Building Resource Center to learn how to install bar rail molding standard bar dimension and specifications how to cut…

Read More »

How to Install Bar Rail

How to Install Bar Rail A short guide to installing Chicago style bar rail: The tools we will be using to fit and install the bar rail molding are a drill, glue, screws, spoil board, biscuit joiner, and biscuits. The sub top should extend out beyond the main bar top 1 and 9/16″ as shown. We first set up the spoil board to hold the bar rail up in position while cutting. We set the miter box angle at 45 degrees and position the bar rail on the spoil board to make the first cut. Next, we reset the miter…

Read More »

The Original Chicago Bar Rail

Are you building a bar, installing and counter in your store, shelving in your home, or finally finishing that man cave? Then you need to know about  BR 475S Chicago Bar Rail! BR 475S Bar Rail is the original style of Chicago Bar Rail. This bar rail style originally appeared in taverns, corner bars, VFW’S, American Legions, firehouses, and pubs throughout the USA in the early 40’s & 50’s. This bar rail style includes a shirt/apron that gives it a much thicker curvy appearance. During that era of bar building the Chicago bar rails were usually made from mahogany and…

Read More »