Archive for May, 2017

Fitting Bar Rail Radius Corners & Straights

Although all of our bar rail molding both radius and straight are made to meet or exceed industry standards for fit and consistency, it may be necessary to scribe and adjust the placement of the seams to achieve optimum results. This is especially true where curved parts intersect with straight parts as the conditions on the job site can vary from those under which the curved and straight parts were made. Not to worry, you can make slight adjustments out or up of either the straight or curved part to make a near perfect transition then sand and feather in…

Read More »

As I near the completion of my Tavern, I thought I would share a photo that contains some of your exceptional products. I used the bar rail, radius corner, and drip edge from your company, and they look great and were of the highest quality. I will send some more pictures when the project is complete.

Thanks,

Michael P. – Oak Forest Illinois

11/24/2020

 

 

BR475 Red Oak Bar Rail, Radius Corner & Drip Edge Moldings

Hello Paul,

Thank you again for your help with my bar project.  I attached a pic of nearly finished top.  I will also be calling you in a little bit to discuss an accompanying pub table.

Chris NauFebruary 3, 2016