Archive for August, 2015

Finishing Your Bar Rail Molding

PRE-FINISHING YOUR BAR RAIL MOLDING PRIOR TO INSTALLATION IS NEVER A GOOD IDEA AND IS NOT RECOMMENDED. Once you have viewed our installation video and have properly installed the bar rail molding we suggest the following steps. Mask off and protect the area where the bar rail meets the main bar top and begin the sanding process with 100 grit sand paper moving on up to 180 grit. Higher grits of sandpaper may be used but keep in mind the higher the grit and polish on the wood the less the stain will penetrate. Natural/clear finishes are not affected as…

Read More »

WOW! Great product and wonderful service. we ordered two BR 475 red oak bar rail sections. one was a 15′ biscuit joint section and the other was a 6′ piece. The order was shipped very quickly; I received it in about a week. The biscuit joint turned out excellent!

WHAT A GREAT TRIM PRODUCT!!!!!

Dan S. – Lancaster, New York

03/29/2020

Red Oak Chicago Bar Rail Molding BR475

Thank u so much for the help purchasing the bar rail. It worked out perfectly and the customer service was by far better than i expected.

Aaron L. – Idaho Falls, Idaho

05/14/19